Nearly every concrete crack repair job requires some cracks to be treated or "fixed." While no crack can ever truly be fixed, Wisebond’s Concrete Crack Patch Filler Paste serves as a wonderful treatment product to help reduce the shadowing through of those cracks into the layer of epoxy coating as well as to minimize the amount of movement and subsequent cracking from the same location in your concrete slab.
Whether you are a DIY homeowner a professional contractor this is the perfect product to prepare and repair your concrete for a new epoxy coating, The crack repair will help to reduce slab movement at critical junctures and help to keep your new epoxy floor coating in pristine condition for a very long time! When repairing a concrete floor, Concrete Crack Patch Filler Paste is easier and less expensive than competitors cement repair products on the market today to repair cement crack problems.
The system is economical not only in product costs but also in tools required for its implementation of repairing cracks concrete may have. This product may be used before the application of an overlay for concrete or as a stand-alone treatment for cracking.
The versatility as our concrete floor crack treatment allows for a relatively wide range in application procedures. However, the main focuses of the treatment process remain the same.
Step 1: All cracks should be "dressed" appropriately by cleaning out with a disk grinding wheel, "V" blade or "crack chaser" equipped with an electric grinder.
Step 2: Make sure crack has been cleared of dust and is dry before application
Step 3: Mix the Concrete Floor Crack & Patch Filler Paste thoroughly, until mixture is one consistent color, being careful not to mix more than you need.
Step 4: Prime the "v-joint," or cleaned out the crack, by brushing the epoxy mixture into the crack making sure it is injected into the crack completely.
Step 5: Pour in either the epoxy mixture, or the silica sand/epoxy mixture and trowel it into the crack surface and leveling to the concrete surface.
Step 6: After approximately 8 hours. and the product has set, use a grinder to remove any excess materials to maintain a flat, even surface.
NOTE: If needed for larger holes, purchase clean, dry, silica sand with the epoxy mixture to create a thick slurry. Silica sand can be purchased at most big-box stores.
Coverage: 0.4 cubic foot or 1/8" X 3/4" x 600' crack
VOC Rating: 0 g/L
Cure: 8 hours ready to grinf level
Shelf Life: 1 year in original unopened container
PART A - CALIFORNIA PROPOSITION 65: This product contains a chemical(s) known to the state of California to cause cancer, birth defects or reproductive harm, which are subject to the requirements of California Proposition 65. FOR MORE INFORMATION GO TO: WWW.P65WARNINGS.CA.GOV.
PART B - CALIFORNIA PROPOSITION 65: This product contains a chemical(s) known to the state of California to cause cancer, birth defects or reproductive harm, which are subject to the requirements of California Proposition 65. FOR MORE INFORMATION GO TO: WWW.P65WARNINGS.CA.GOV.
© 2023 - WiseBond®, A product of DeckWise®, The Ipe Clip® Fastener Company