Quick-Set Seal Epoxy

In Stock, ready to ship
$36.95

For Live-Edge Wood Slabs and Crack Filling

WiseBond® Quick Set Seal is a medium viscosity, fast setting epoxy designed to seal live-edge wood slabs and coating porous substrates as used for wood table building. Additionally, it is useful as a quick patching material to fill small cracks, voids and blemishes.

Time is money! This epoxy sets up quickly and allows you to keep on track and on schedule building wooden tables and furniture. No need to wait 24 hours after sealing your wood edges. Woodworkers love quick setting epoxy to seal live-edges preventing bubbles during their deep pouring and river table builds.



We do not offer samples of our products. Why not?
CAUTION! Only mix as much as needed in small batches. This quick setting epoxy has a very short pot life and unused epoxy will begin to overheat within 10-12 minutes when left in mixing containers. Do not allow extra unused epoxy to sit! Pour all unused epoxy onto a scrap piece of wood or piece of cardboard in a thin layer to prevent overheating.

Formulated from the same raw materials as our Deep Pour 2 inch single pour epoxy and super gloss Bar and Table Top Epoxy, it matches seamlessly and bonds flawlessly.

Quick Coat Seal can also fill small cracks and voids before flood coat resin application to prevent surface bubbles for a smoother topcoat. Let harden 2-3 hours before sanding cracks and voids. Porous substrates may need additional applications.

This 1:1 ratio kit includes 1 pint of A Resin and 1 pint of B Hardener of our fast setting wood epoxy. It has a 10-12 minute pot life and approximately a 15 minute work time. Don’t dilly-dally!

Surface Prep:  All wood surfaces must be clean and free of oil or dust before applying. Remove any grease or oil with acetone. A wire brush may be helpful to clean live-edge crevasses and wood grain.

Directions: Mix for 3 minutes with a mixing stick. Brush on live-edges with a small brush similar to a glue brush. (Do not use a foam brush as it may introduce small air bubbles during application.) Brush on a thin coat and allow to preferably cure hard to the touch (or very tacky) before applying additional seal coats. Let dry for 1 to 1-1/2 hours – hard to the touch - before pouring our WiseBond® Deep Pour epoxy. A fan or a heat gun may be used to speed up the dry time, if necessary.

Do not add any extra solvents or agents to the mixture to try and encourage a quicker cure. Quick Set Seal epoxy is not designed to accept these and you will end up with an epoxy resin that may not cure at all. 

Part A - CALIFORNIA PROPOSITION 65: WARNING: This product can expose you to chemicals including (Bisphenol A CAS 80-05-7, and Epichlorohydrin CAS 106-89-8), which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Part B: - CALIFORNIA PROPOSITION 65: WARNING: This product can expose you to the chemical (Propylene Oxide CAS 75-56-9) which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

Warning: We do not advise using quick-set with colored pigments, as unpredictable color results may occur.

 

img

Added to cart successfully!